1
Preparation for installation
- Plan the best layout for the floor heating pipe.
- Clean the floor.
- Lay the insulation sheets if required.
2
Install the bottom panels of HOYA ONDOL
- Start laying the panels.
- Lay panels side by side along the edge of a wall in the most appropriate orientation.
- Continue to lay panels across the rest of the floor.
- Note: Take care to align panels accurately.
3
Install the Pex(PE-RT) pipe
- The size of the pipe is 12mm(ID) and 16mm(OD).
- Roll out the pipe pushing it into the channels of the bottom panels.
- Unroll the pipe hand over hand to avoid twisting.
- Do not kink the pipe by trying to make a very tight turn.
- The pipe should run start and finish at the manifold, by fitting the manifold in place before laying the pipe.
- Allow sufficient pipe for cutting and fitting at a later stage.
4
Install the top panels of HOYA ONDOL
- Snap-fit the top and bottom panels.
- Use the rubber mallet hammer for easy work.
5
Connect the pipes to the manifold
- Connect the pipes to the manifold by using coupling sockets.
- Be careful not to kink the pipes.
6
Connect the boiler
- Connect the manifold to the boiler by certified engineer according to the local regulation.
7
Completion of installation
- Commissioning.
8
Install the flooring material
HOYA ONDOL is the unique hydronic radiant system
for easy installation and energy saving.
Learn More
Innovation for hydronic radiant
heating system
heating system
DIY Assembly Package Product
How Different Quality on HOYA ONDOL
